Junger-audio D*AP8 Digital Audio Processor Manuel d'utilisateur télécharger pdf (Page 62)

D*AP8

setup GUI – AUDIO PROCESSOR – Fail Over (4 x 2 program configuration)

For the 4x2 Program Configuration (SYSTEM > Setup > Program Configuration) the D*AP8 offers

four independent Fail Over circuits (see Overview sketch).

The source for the Fail Over circuit can be either the adjacent program input (e.g. input 2L/R for the

program input 1L/1R) or the AUX input. The Mode switch will select the respective signal path.

See the example above for the four program outputs :

program 1 (1L/1R) has a valid input signal and is prepared for auto switch over

to the second program input 2L/2R.

program 2 (2L/2R) has no valid input and has automatically switched over

to the AUX input.

program 3 (3L/3R) has a valid input and is prepared for auto switch over

to input 4L/4R, input 4L/4R has valid input.

This is indicated by the yellow soft LED.

program 4 (4L/4R) is fix connected to AUX. Signal input is mono L.

Fail Over 1L/1R Example description of the fail over function blocks

MODE The Fail Over output can be permanently

connected to:

* its program input 1L/1R

* its adjacent program input 2L/2R

* or to the AUX input.

Automatic switch over in case of an input

failure may be configured for the AUX or the

adjacent 2L/2R input.

1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 99 100

Pas de commentaire

Junger-audio D*AP8 Digital Audio Processor Manuel d'utilisateur Page 62