Junger-audio D*AP8 Digital Audio Processor Manuel d'utilisateur télécharger pdf (Page 29)

D*AP8

Group 1 – 4 The embedding process distinguishes between 4 different modes for each

group independently:

Embedding – a new group will be built

Replace – the structure of the group from the input is kept and the audio

content is simple replaced

Delete – the group from the input is deleted

OFF – the embedder fro that group is turned off

VANC Metadata [Enabled - / Disabled – (selected SDID#)]

Embedder Status For details see SMPTE 2020-2 standard.

ARIB STD-B39 Meta information standard

Control Data Status

Status [Available / Not Available]

Audio Mode See ARIB Japanese standard "Structure of Inter-Stationary Control Data

Conveyed by Ancillary Data Packets"

http://www.arib.or.jp/english/html/overview/doc/2-STD-B39v1_2.pdf

Setup GUI – INTERFACES – SDI I/O interface – Local Routing

The SDI interface comes with a local routing matrix to shuffle audio signals from and to the system (device)

(i.e. to and from the central device router) and from and to the physical de-embedders / embedders.

The example below shows the default routing that sends all signals 1:1 from the physical de-embedders

[INTERFACE – SDI IN G1 CH1 … SDI IN G4 CH4] to the internal device matrix

[SYSTEM – SDI De-Embedder DEM 1 … DEM 16].

The signals from the device router [SYSTEM – SDI Embedder EMB 1 … EMB 16] are routed by default

1:1 to the physical embedders [INTERFACE – SDI OUT G1 CH1 … G4 CH4].

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 99 100

Pas de commentaire

Junger-audio D*AP8 Digital Audio Processor Manuel d'utilisateur Page 29