Junger-audio b42 - Dynamics Processor Manuel d'utilisateur télécharger pdf (Page 17)

3. INSTALLATION

Operation manual b42, chapter 3 -installation- page 3-3

Electrical specification:

GPI input potential free by opto-coupler, low active

OFF: +3.5…+30V between GPI input

and pin14

ON: less then 1.5V

Min 50ms

Note: If using an external voltage feed it has to be connected to pin 14!

External Ground is switching the GPI on any of the inputs.

An internal voltage feed is available on pin 15. Ground is available from the

shield of the connector only! By using the internal voltage feed there is no

electrical isolation given anymore.

The digital dynamics processor b42 can transmit specific device

statuses via parallel Tally lines.

use: Control of the remote-controlled changeover of

presets

connector: D-SUB 15pin, male

3.7.2

TALLY OUT

min. 50 ms

+1,5V

+3,5...30V

Pin1...13

Ext. voltage

feed+3

5...30V

Pin14

Contact to

ext. Ground

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 43 44

Pas de commentaire

Junger-audio b42 - Dynamics Processor Manuel d'utilisateur Page 17